Contract No. DE-AC36-99-GO10337NOTICE The submitted manuscript has been offered by an employee of the Midwest Research Institute (MRI), a contractor of the US Government under Contract No. DE-AC36-99GO10337. Accordingly, the US Government and MRI retain a nonexclusive royalty-free license to publish or reproduce the published form of this contribution, or allow others to do so, for US Government purposes. This report was prepared as an account of work sponsored by an agency of the United States government. Neither the United States government nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any information, apparatus, product, or process disclosed, or represents that its use would not infringe privately owned rights. Reference herein to any specific commercial product, process, or service by trade name, trademark, manufacturer, or otherwise does not necessarily constitute or imply its endorsement, recommendation, or favoring by the United States government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States government or any agency thereof. Available electronically at

Abstract:- Modelling a small turbine is of interest due to the rapid development of small jet engines for model aircraft and UAVs. Because of its size, a small jet engine has small air mass flow rate, low component pressure ratios, high rotational speed and relatively low Reynolds number

work on the response of meters to step changes but no reports have been found of the response of meters to sinusoidally pulsating flows. "Small " turbine meters are expected to behave differently from "large " meters for a number of reasons: a smaller meter would generally have: (1

Small wind turbines with permanent magnet alternators (PMA) seldom have active speed control systems. The turbines rely on passive mechanisms such as furling and/or blade flutter to control the rotational speed. These passive methods cause high mechanical stresses and undesirable noise. One method

Abstract not found

Small turbine blade inspection using

Point estimate method for voltage unbalance evaluation in residential distribution networks with high penetration of small wind turbines

Recently, increased attention has been paid to small gas turbine units. Microturbines with fuel cells and microturbines with heaters in a Combined Heat and Power (CHP) arrangement are showing great promise for supplying distributed electric and shaft power and process or space heat. Small jet

The aim of this study is to design a steam turbine for a small scale steam power plant and industrializes the design, the turbine driven by the energy of coconut shells; a renewable energy source with lower cost, as the source of energy. The study was concentrated on steam cycle, type of turbine

In fulfilment of the requirements of