### TABLE I COMPARISON OF DIFFERENT SAMPLING SCHEMES. Sampling scheme: Nyquist one-bit dither b-bit dither, 1 lt; b lt; k

707

### Table 11, the mismatch ratios associated with the one bit and two bit correlation are, respectively

"... In PAGE 3: ... By imposing a threshold, the two bit correlation reduces the probability of mismatch associated with one bit correlation. A set of conditions that create mismatches for either one bit or two bit correlation is listed in Table11 , where A + B represents a sample moved from region A to B because of the induced noise sample n. When matching signals with less information, such as one bit or two bit correlation, the likelihood of mismatch- ing samples may increase relative to the situation where full information is available.... In PAGE 3: ...where A is a factor that is not seen in Table11 ; it represents the additional percentage of mismatches induced by imposing a noise tolerance. Consider the situation where signal s is I+, i.... ..."

### TABLE I THE OUTPUT CLUSTERING RESULTS FOR THE ONE-BIT LINES CIRCUIT net1026.

2005

Cited by 2

### Table 1. Output unreliabilitiesof a one-bit NAND multiplexing circuit (von Neumann fault).

2003

### Table 2. Output unreliabilities of a one-bit NAND multiplexing circuit (stuck-at-0 fault).

2003

### Table 3. Output unreliabilities of a one-bit NAND multiplexing circuit (stuck-at-1 fault).

2003

### Table 5. Dempster-Shafer calculations with one bit error.

"... In PAGE 31: ...e will reduce its confidence to 0.75. All other test confidences will be set to 0.99 The results of processing all eight test vectors through the Dempster- Shafer calculations with the diagnostic inference model are given in Table5 . The normalized values for evidential probability, though quite low, show the leading candidates for diagnosis are c1 and nf.... ..."

### Table 5: Experimental results of DSA in designing multiplierless QMF-bank problem 24c, starting from a six ONE-BIT expression of scaled Johnston apos;s solutions.

1997

"... In PAGE 24: ... We further set the scaling factor to be 0:6413, the same as that in DLM-98 for 24c. Table5 lists the eight designs found by DSA. When the initial temperature was too high ( 5:0), DSA did not nd any meaningful design, but found near feasible designs when the initial temperature is lower.... ..."

Cited by 12

### Table 7 : Codes for one bit per symbol found with s s R G 2 2 = 20dB

"... In PAGE 7: .......... 92 Figure 43: Simulation of m = 4 and m = 6 R = 1/X codes (from Table7 ) on an ideally interleaved Rayleigh fading channel with Laplacian noise .... In PAGE 8: ................... 69 Table7 : Codes for one bit per symbol found with s s R G 2 2 = 20dB .... ..."

### TABLE I TRIVIAL CODEBOOK GENERATED FOR Mt = 2 AND N = 2 (ONE BIT).

2003

Cited by 101