We introduce a geographical adaptive fidelity (GAF) algorithm that reduces energy consumption in ad hoc wireless networks. GAF conserves energy by identifying nodes that are equivalent from a routing perspective and then turning off unnecessary nodes, keeping a constant level of routing fidelity. GAF moderates this policy using application- and system-level information; nodes that source or sink data remain on and intermediate nodes monitor and balance energy use. GAF is independent of the underlying ad hoc routing protocol; we simulate GAF over unmodified AODV and DSR. Analysis and simulation studies of GAF show that it can consume 40% to 60% less energy than an unmodified ad hoc routing protocol. Moreover, simulations of GAF suggest that network lifetime increases proportionally to node density; in one example, a four-fold increase in node density leads to network lifetime increase for 3 to 6 times (depending on the mobility pattern). More generally, GAF is an example of adaptive fidelity, a technique proposed for extending the lifetime of self-configuring systems by exploiting redundancy to conserve energy while maintaining application fidelity.

Energy-aware design and evaluation of network protocols requires knowledge of the energy consumption behavior of actual wireless interfaces. But little practical information is available about the energy consumption behavior of well-known wireless network interfaces and device specifications do not provide information in a form that is helpful to protocol developers. This paper describes a series of experiments which obtained detailed measurements of the energy consumption of an IEEE 802.11 wireless network interface operating in an ad hoc networking environment. The data is presented as a collection of linear equations for calculating the energy consumed in sending, receiving and discarding broadcast and pointto -point data packets of various sizes. Some implications for protocol design and evaluation in ad hoc networks are discussed. Keywords---energy consumption, IEEE 802.11, ad hoc networks I.

This paper discusses online power-aware routing in large wireless ad-hoc networks for applications where the message sequence is not known. We seek to optimize the lifetime of the network. We show that online power-aware routing does not have a constant competitive ratio to the off-line optimal algorithm. We develop an approximation algorithm called max-min zPmin that has a good empirical competitive ratio. To ensure scalability, we introduce a second online algorithm for power-aware routing. This hierarchical algorithm is called zone-based routing. Our experiments show that its performance is quite good.

We evaluate several routing protocols for mobile, wireless, ad hoc networks via packet level simulations. The protocol suite includes routing protocols specifically designed for ad hoc routing, as well as more traditional protocols, such as link state and distance vector, used for dynamic networks. Performance is evaluated with respect to fraction of packets delivered, end-to-end delay and routing load for a given traffic and mobility model. It is observed that the new generation of on-demand routing protocols use much lower routing load. However, the traditional link state and distance vector protocols provide, in general, better packet delivery and delay performance. 1. Introduction A mobile, ad hoc network [4] is an autonomous system of mobile hosts connected by wireless links. There is no static infrastructure such as base stations. If two hosts are not within radio range, all message communication between them must pass through one or more intermediate hosts that double as router...

In this paper, we consider the problem of power control when nodes are non-homogeneously dispersed in space. In such situations, one seeks to employ per packet power control depending on the source and destination of the packet. This gives rise to a joint problem which involves not only power control but also clustering. We provide three solutions for joint clustering and power control.

Mobile ad hoc networking (MANET) has become an exciting and important technology in recent years because of the rapid proliferation of wireless devices. MANETs are highly vulnerable to attacks due to the open medium, dynamically changing network topology, cooperative algorithms, lack of centralized monitoring and management point, and lack of a clear line of defense. In this paper, we report our progress in developing intrusion detection (ID) capabilities for MANET. Building on our prior work on anomaly detection, we investigate how to improve the anomaly detection approach to provide more details on attack types and sources. For several well-known attacks, we can apply a simple rule to identify the attack type when an anomaly is reported. In some cases, these rules can also help identify the attackers. We address the run-time resource constraint problem using a cluster-based detection scheme where periodically a node is elected as the ID agent for a cluster. Compared with the scheme where each node is its own ID agent, this scheme is much more efficient while maintaining the same level of effectiveness. We have conducted extensive experiments using the ns-2 and MobiEmu environments to validate our research. 1.

Several distributed routing algorithms for wireless networks were described recently, based on location information of nodes available via Global Positioning System (GPS). In greedy routing algorithm sender or node S currently holding the message m forwards m to one of its neighbors that is the closest to destination. The algorithm fails if S does not have any neighbor that is closer to destination than S. FACE algorithm guarantees the delivery of m if the network, modeled by unit graph, is connected. GFG algorithm combines greedy and FACE algorithms. Greedy algorithm is applied as long as possible, until delivery or a failure. In case of failure, the algorithm switches to FACE algorithm until a node closer to destination than last failure node is found, at which point greedy algorithm is applied again. In this paper we further improve the performance of GFG algorithm, by reducing its average hop count. First we improve the FACE algorithm by adding a sooner-back procedure for earlier escape from FACE mode. Then we perform a shortcut procedure at each forwarding node S. Node S uses the local information available to calculate as many hops as possible and forwards the packet to the last known hop directly instead of forwarding it to the next hop. The second improvement is based on the concept of dominating sets. The network of internal nodes defines a connected dominating set, and each node must be either internal or directly connected to an internal node. We apply several existing definitions of internal nodes, namely the concepts of intermediate, inter-gateway and gateway nodes. We propose to run GFG routing, enhanced by shortcut procedure, on the dominating set, except possibly the first and last hops. We obtained localized routing algorithm that guarantees delivery an...

In the paper, we devise and evaluate a fully decentralized, light-weight, dynamic clustering algorithm for target tracking. Instead of assuming the same role for all the sensors, we envision a hierarchical sensor network that is composed of (a) a static backbone of sparsely placed high-capability sensors which will assume the role of a cluster head (CH) upon triggered by certain signal events; and (b) moderately to densely populated low-end sensors whose function is to provide sensor information to CHs upon request. A cluster is formed and a CH becomes active, when the acoustic signal strength detected by the CH exceeds a pre-determined threshold. The active CH then broadcasts an information solicitation packet, asking sensors in its vicinity to join the cluster and provide their sensing information. We address and devise solution approaches (with the use of Voronoi diagram) to realize dynamic clustering: (I1) how CHs cooperate with one another to ensure that only one CH (preferably the CH that is closest to the target) is active with high probability; (I2) when the active CH solicits for sensor information, instead of having all the sensors in its vicinity reply, only a sufficient number of sensors respond with non-redundant, essential information to determine the target location; and and (I3) both the packets that sensors send to their CHs and packets that CHs report to subscribers do not incur significant collision. Through both probabilistic analysis and ns-2 simulation, we show with the use of Voronoi diagram, the CH that is usually closest to the target is (implicitly) selected as the leader and and that the proposed dynamic clustering algorithm effectively eliminates contention among sensors and renders more accurate estimates of target locations as a result of better quality data collected and less collision incurred.

Abstract. The efficient subdivision of a sensor network into uniform, mostly non-overlapping clusters of physically close nodes is an important building block in the design of efficient upper layer network functions such as routing, broadcast, data aggregation, and query processing. We present ACE, an algorithm that results in highly uniform cluster formation that can achieve a packing efficiency close to hexagonal close-packing. By using the self-organizing properties of three rounds of feedback between nodes, the algorithm induces the emergent formation of clusters that are an efficient cover of the network, with significantly less overlap than the clusters formed by existing algorithms. The algorithm is scale-independent — it completes in time proportional to the deployment density of the nodes regardless of the overall number of nodes in the network. ACE requires no knowledge of geographic location and requires only a small constant amount of communications overhead. 1

In this paper, we present a middleware architecture for coordination services in sensor networks that facilitates interaction between groups of sensors which monitor different environmental events. It sits on top of the native routing infrastructure and exports the abstraction of mobile communication endpoints maintained at the locations of such events. A single logical destination is created and maintained for every environmental event of interest. Such destinations are uniquely labeled and can be used for communication by application-level algorithms for coordination and sensory data management between the different event locales. For example, they may facilitate coordination, in a distributed intrusion scenario, among nodes in the vicinity of the intruders.