For many years, scalable routing for wireless communication systems was a compelling but elusive goal. Recently, several routing algorithms that exploit geographic information (e.g., GPSR) have been proposed to achieve this goal. These algorithms refer to nodes by their location, not address, and use those coordinates to route greedily, when possible, towards the destination. However, there are many situations where location information is not available at the nodes, and so geographic methods cannot be used. In this paper we define a scalable coordinate-based routing algorithm that does not rely on location information, and thus can be used in a wide variety of ad hoc and sensornet environments. 1.

We describe an SDP relaxation based method for the position estimation problem in wireless sensor networks. The optimization problem is set up so as to minimize the error in sensor positions to fit distance measures. Observable gauges are developed to check the quality of the point estimation of sensors or to detect erroneous sensors. The performance of this technique is highly satisfactory compared to other techniques. Very few anchor nodes are required to accurately estimate the position of all the unknown nodes in a network. Also the estimation errors are minimal even when the anchor nodes are not suitably placed within the network or the distance measurements are noisy.

Abstract — It is often useful to know the geographic positions of nodes in a communications network, but adding GPS receivers or other sophisticated sensors to every node can be expensive. MDS-MAP is a recent localization method based on multidimensional scaling (MDS). It uses connectivity information—who is within communications range of whom—to derive the locations of the nodes in the network, and can take advantage of additional data, such as estimated distances between neighbors or known positions for certain anchor nodes, if they are available. However, MDS-MAP is an inherently centralized algorithm and is therefore of limited utility in many applications. In this paper, we present a new variant of the MDS-MAP method, which we call MDS-MAP(P) standing for MDS-MAP using patches of relative maps, that can be executed in a distributed fashion. Using extensive simulations, we show that the new algorithm not only preserves the good performance of the original method on relatively uniform layouts, but also performs much better than the original on irregularly-shaped networks. The main idea is to build a local map at each node of the immediate vicinity and then merge these maps together to form a global map. This approach works much better for topologies in which the shortest path distance between two nodes does not correspond well to their Euclidean distance. We also discuss an optional refinement step that improves solution quality even further at the expense of additional computation. I.

In many applications of wireless sensor networks (WSN), sensors are deployed un-tethered in hostile environments. For locationaware WSN applications, it is essential to ensure that sensors can determine their location, even in the presence of malicious adversaries. In this paper we address the problem of enabling sensors of WSN to determine their location in an un-trusted environment. Since localization schemes based on distance estimation are expensive for the resource constrained sensors, we propose a rangeindependent localization algorithm called SeRLoc. SeRLoc is distributed algorithm and does not require any communication among sensors. In addition, we show that SeRLoc is robust against severe WSN attacks, such as the wormhole attack, the sybil attack and compromised sensors. To the best of our knowledge, ours is the first work that provides a security-aware range-independent localization scheme for WSN. We present a threat analysis and comparison of the performance of SeRLoc with state-of-the-art range-independent localization schemes.

Accurate and low-cost sensor localization is a critical requirement for the deployment of wireless sensor networks in a wide variety of applications. Low-power wireless sensors may be many hops away from any other sensors with a priori location information. In cooperative localization, sensors work together in a peer-to-peer manner to make measurements and then form a map of the network. Various application requirements (such as scalability, energy efficiency, and accuracy) will influence the design of sensor localization systems. In this article, we describe measurement-based statistical models useful to describe time-of-arrival (TOA), angle-of-arrival (AOA), and received-signal-strength (RSS) measurements in wireless sensor networks. Wideband and ultra-wideband (UWB) measurements, and RF and acoustic media are also discussed. Using the models, we show how to calculate a Cramér-Rao bound (CRB) on the location estimation precision possible for a given set of measurements. This is a useful tool to help system designers and researchers select measurement technologies and evaluate localization algorithms. We also briefly survey a large and growing body of sensor localization algorithms. This article is intended to emphasize the basic statistical signal processing background necessary to understand the state-of-the-art and to make progress in the new and largely open areas of sensor network localization research.

APS algorithms use the basic idea of distance vector routing to find positions in an ad hoc network using only a fraction of landmarks, for example GPS enabled nodes. All the nodes in the network are assumed to have the possibility of measuring: range, angle of arrival (AOA), orientation, or a combination of them. We give a lower bound for positioning error in a multihop network for a range/angle free algorithm, and examine the error characteristics of four classes of multihop APS algorithms under various conditions, using theoretical analysis and simulations. Analysis of range/angle free, range based, angle based, and multimodal algorithms shows a complex tradeo# between the capabilities used, the density of the network, ratio of landmarks, and the quality of the positions obtained.

Abstract—We propose an approach that uses connectivity information—who is within communications range of whom—to derive the locations of nodes in a network. The approach can take advantage of additional information, such as estimated distances between neighbors or known positions for certain anchor nodes, if it is available. It is based on multidimensional scaling (MDS), an efficient data analysis technique that takes Oðn 3 Þ time for a network of n nodes. Unlike previous approaches, MDS takes full advantage of connectivity or distance information between nodes that have yet to be localized. Two methods are presented: a simple method that builds a global map using MDS and a more complicated one that builds small local maps and then patches them together to form a global map. Furthermore, least-squares optimization can be incorporated into the methods to further improve the solutions at the expense of additional computation. Through simulation studies on uniform as well as irregular networks, we show that the methods achieve more accurate solutions than previous methods, especially when there are few anchor nodes. They can even yield good relative maps when no anchor nodes are available. Index Terms—Wireless sensor networks, optimization, position estimation. 1

An SDP relaxation based method is developed to solve the localization problem in sensor networks using incomplete and inaccurate distance information. The problem is set up to find a set of sensor positions such that given distance constraints are satisfied. The nonconvex constraints in the formulation are then relaxed in order to yield a semidefinite program which can be solved efficiently. The basic model is extended in order to account for noisy distance information. In particular, a maximum likelihood based formulation and an interval based formulation are discussed. The SDP solution can then also be used as a starting point for steepest descent based local optimization techniques that can further refine the SDP solution. We also describe the extension of the basic method to develop an iterative distributed SDP method for solving very large scale semidefinite programs that arise out of localization problems for large dense networks and are intractable using centralized methods. The performance evaluation of the technique with regard to estimation accuracy and computation time is also presented by the means of extensive simulations. Our SDP scheme also seems to be applicable to solving other Euclidean geometry problems where points are locally connected.

In many applications of wireless ad hoc and sensor networks, position-awareness is of great importance. Often, as in the case of geometric routing, it is sufficient to have virtual coordinates, rather than real coordinates. In this paper, we address the problem of obtaining virtual coordinates based on connectivity information. In particular, we propose the first approximation algorithm for this problem and discuss implementational aspects.

Sensor positioning is a crucial part of many location-dependent applications that utilize wireless sensor networks (WSNs). Current localization approaches can be divided into two groups: range-based and range-free. Due to the high costs and critical assumptions, the range-based schemes are often impractical for WSNs. The existing range-free schemes, on the other hand, suffer from poor accuracy and low scalability. Without the help of a large number of uniformly deployed seed nodes, those schemes fail in anisotropic WSNs with possible holes. To address this issue, we propose the Rendered Path (REP) protocol. To the best of our knowledge, REP is the only range-free protocol for locating sensors with constant number of seeds in anisotropic sensor networks.