Abstract—We develop and analyze low-complexity cooperative diversity protocols that combat fading induced by multipath propagation in wireless networks. The underlying techniques exploit space diversity available through cooperating terminals’ relaying signals for one another. We outline several strategies employed by the cooperating radios, including fixed relaying schemes such as amplify-and-forward and decode-and-forward, selection relaying schemes that adapt based upon channel measurements between the cooperating terminals, and incremental relaying schemes that adapt based upon limited feedback from the destination terminal. We develop performance characterizations in terms of outage events and associated outage probabilities, which measure robustness of the transmissions to fading, focusing on the high signal-to-noise ratio (SNR) regime. Except for fixed decode-and-forward, all of our cooperative diversity protocols are efficient in the sense that they achieve full diversity (i.e., second-order diversity in the case of two terminals), and, moreover, are close to optimum (within 1.5 dB) in certain regimes. Thus, using distributed antennas, we can provide the powerful benefits of space diversity without need for physical arrays, though at a loss of spectral efficiency due to half-duplex operation and possibly at the cost of additional receive hardware. Applicable to any wireless setting, including cellular or ad hoc networks—wherever space constraints preclude the use of physical arrays—the performance characterizations reveal that large power or energy savings result from the use of these protocols. Index Terms—Diversity techniques, fading channels, outage probability, relay channel, user cooperation, wireless networks. I.

Abstract—Upper and lower bounds on the capacity and minimum energy-per-bit for general additive white Gaussian noise (AWGN) and frequency-division AWGN (FD-AWGN) relay channel models are established. First, the max-flow min-cut bound and the generalized block-Markov coding scheme are used to derive upper and lower bounds on capacity. These bounds are never tight for the general AWGN model and are tight only under certain conditions for the FD-AWGN model. Two coding schemes that do not require the relay to decode any part of the message are then investigated. First, it is shown that the “side-information coding scheme ” can outperform the block-Markov coding scheme. It is also shown that the achievable rate of the side-information coding scheme can be improved via time sharing. In the second scheme, the relaying functions are restricted to be linear. The problem is reduced to a “single-letter ” nonconvex optimization problem for the FD-AWGN model. The paper also establishes a relationship between the minimum energy-per-bit and capacity of the AWGN relay channel. This relationship together with the lower and upper bounds on capacity are used to establish corresponding lower and upper bounds on the minimum energy-per-bit that do not differ by more than a factor of 1 45 for the FD-AWGN relay channel model and 1 7 for the general AWGN model. Index Terms—Additive white Gaussian noise (AWGN) channels, channel capacity, minimum energy-per-bit, relay channel. I.

Abstract—The goal of this paper is to establish which practical routing schemes for wireless networks are most suitable for power-limited and bandwidth-limited communication regimes. We regard channel state information (CSI) at the receiver and point-to-point capacity-achieving codes for the additive white Gaussian noise (AWGN) channel as practical features, interference cancellation (IC) as possible, but less practical, and synchronous cooperation (CSI at the transmitters) as impractical. We consider a communication network with a single source node, a single destination node, and I intermediate nodes placed equidistantly on a line between them. We analyze the minimum total transmit power needed to achieve a desired end-to-end rate for several schemes and demonstrate that multihop communication with spatial reuse performs very well in the power-limited regime, even without IC. However, within a class of schemes not performing IC, single-hop transmission (directly from source to destination) is more suitable for the bandwidth-limited regime, especially when higher spectral efficiencies are required. At such higher spectral efficiencies, the gap between single-hop and multihop can be closed by employing IC, and we present a scheme based upon backward decoding that can remove all interference from the multihop system with an arbitrarily small rate loss. This new scheme is also used to demonstrate that rates of @�� � A are achievable over linear wireless networks even without synchronous cooperation. Index Terms—Cooperation, network information theory, relay networks, routing, wireless networks. I.

In this paper, the effect of spatial diversity on the throughput and reliability of wireless networks is examined. Spatial diversity is realized through multiple independently fading transmit/receive antenna paths in single-user communication and through independently fading links in multiuser communication. Adopting spatial diversity as a central theme, we start by studying its information-theoretic foundations, then we illustrate its benefits across the physical (signal transmission/coding and receiver signal processing) and networking (resource allocation, routing, and applications) layers. Throughout the paper, we discuss engineering intuition and tradeoffs, emphasizing the strong interactions between the various network functionalities.