An ad hoc network is a collection of wireless mobile hosts forming a temporary network without the aid of any established infrastructure or centralized administration. In such an environment, it may be necessary for one mobile host to enlist the aid of other hosts in forwarding a packet to its destination, due to the limited range of each mobile host’s wireless transmissions. This paper presents a protocol for routing in ad hoc networks that uses dynamic source routing. The protocol adapts quickly to routing changes when host movement is frequent, yet requires little or no overhead during periods in which hosts move less frequently. Based on results from a packet-level simulation of mobile hosts operating in an ad hoc network, the protocol performs well over a variety of environmental conditions such as host density and movement rates. For all but the highest rates of host movement simulated, the overhead of the protocol is quite low, falling to just 1 % of total data packets transmitted for moderate movement rates in a network of 24 mobile hosts. In all cases, the difference in length between the routes used and the optimal route lengths is negligible, and in most cases, route lengths are on average within a factor of 1.01 of optimal. 1.

An ad hoc network is a collection of wireless mobile nodes dynamically forming a temporary network without the use of any existing network infrastructure or centralized administration. Due to the limited transmission range of wireless network interfaces, multiple network "hops " may be needed for one node to exchange data with another across the network. In recent years, a variety of new routing protocols targeted specifically at this environment have been developed, but little performance information on each protocol and no realistic performance comparison between them is available. This paper presents the results of a detailed packet-level simulation comparing four multi-hop wireless ad hoc network routing protocols that cover a range of design choices: DSDV, TORA, DSR, and AODV. We have extended the ns-2 network simulator to accurately model the MAC and physical-layer behavior of the IEEE 802.11 wireless LAN standard, including a realistic wireless transmission channel model, and present the results of simulations of networks of 50 mobile nodes. 1

This paper describes a new operating system kernel, called the x-kernel, that provides an explicit architecture for constructing and composing network protocols. Our experience implementing and evaluating several protocols in the x-kernel shows that this architecture is both general enough to accommodate a wide range of protocols, yet efficient enough to perform competitively with less structured operating systems. 1 Introduction Network software is at the heart of any distributed system. It manages the communication hardware that connects the processors in the system and it defines abstractions through which processes running on those processors exchange messages. Network software is extremely complex: it must hide the details of the underlying hardware, recover from transmission failures, ensure that messages are delivered to the application processes in the appropriate order, and manage the encoding and decoding of data. To help manage this complexity, network software is divi...

The Dynamic Source Routing protocol (DSR) is a simple and efficient routing protocol designed specifically for use in multi-hop wireless ad hoc networks of mobile nodes. DSR allows the network to be completely self-organizing and self-configuring, without the need for any existing network infrastructure or administration. The protocol is composed of the two mechanisms of Route Discovery and Route Maintenance, which work together to allow nodes to discover and maintain source routes to arbitrary destinations in the ad hoc network. The use of source routing allows packet routing to be trivially loop-free, avoids the need for up-to-date routing information in the intermediate nodes through which packets are forwarded, and allows nodes forwarding or overhearing packets to cache the routing information in them for their own future use. All aspects of the protocol operate entirely on-demand, allowing the routing packet overhead of DSR to scale automatically to only that needed to react to changes in the routes currently in use. We have evaluated the operation of DSR through detailed simulation on a variety of movement and communication patterns, and through implementation and significant experimentation in a physical outdoor ad hoc networking testbed we have constructed in Pittsburgh, and have demonstrated the excellent performance of the protocol. In this chapter, we describe the design of DSR and provide a summary of some of our simulation and testbed implementation results for the protocol. 1

Abstract not found

An ad hoc network is a collection of wireless mobile hosts forming a temporary network withoutthe aid of any centralized administration or standard support services. In such an environment, it may be necessary for one mobile host to enlist the aid of others in forwarding a packet to its destination, due to the limited propagation range of each mobile host's wireless transmissions. Some previous attempts have been made to use conventional routing protocols for routing in ad hoc networks, treating each mobile host as a router. This position paper points out a number of problems with this design and suggests a new approach based on separate route discovery and route maintenance protocols.

We consider the problem of providing network access to hosts whose physical location changes with time. Such hosts cannot depend on traditional forms of network connectivity and routing because their location, and hence the route to reach them, cannot be deduced from their network address. In this paper, we explore the concept of providing continuous network access to mobile computers, and present a set of IP-based protocols that achieve that goal. They are primarily targeted at supporting a campus environment with mobile computers, but also extend gracefully to accommodate hosts moving between different networks. The key feature is the dependence on ancillary machines, the Mobile Support Stations (MSSs), to track the location of the Mobile Hosts. Using a combination of caching, forwarding pointers, and timeouts, a minimal amount of state is kept in each MSS. The state information is kept in a distributed fashion; the system scales well, reacts quickly to changing topologies, and does ...

Network software is a critical component of any distributed system. Because of its complexity, network software is commonly layered into a hierarchy of protocols, or more generally, into a protocol graph Typical protocol graphs-including those standardized in the IS0 and TCP/IP network architectures-share three important properties: the protocol graph is simple, the nodes of the graph (protocols) encapsulate complex functionality, and the topology of the graph is relatively static. This paper describes a new way to organize network software that differs from conventional architectures in all three of these properties In our approach, the protocol graph is complex, individual protocols encapsulate a single function. and the topology of the graph is dynamic. The main contribution of this paper is to describe the ideas behind our new architec-ture, illustrate the advantages of using the architecture, and demonstrate that the architecture results in efficient network software.

Abstract -- Existing distributed systems vary from those which merely provide Existing distributed systems vary from those which merely provide interconnection of autonomous systems to those which provide a complete language interconnection of autonomous systems to those which provide a complete language environment for writing distributed programs. The former tend to support flexibility and environment for writing distributed programs. The former tend to support flexibility and provide ready access to system facilities, but suffer by being complex to use. Language provide ready access to system facilities, but suffer by being complex to use. Language environments are simpler to use and can provide safer environments by performing checks, but environments are simpler to use and can provide safer environments by performing checks, but tend to be aimed at constructing distributed programs rather than systems, and tend to hide and tend to be aimed at constructing distributed programs rath...

Read it as an adjunct to the lectures on distributed systems, links, and switching. It gives a fairly complete description of a working highly-available switched network providing daily service to about 100 hosts. The techniques used to obtain high reliability and fault-tolerance are characteristic of many distributed systems, not just of networks. The paper also makes clear the essential role of software in modern networks.