Reliable transport protocols such as TCP are tuned to perform well in traditional networks where packet losses occur mostly because of congestion. However, networks with wireless and other lossy links also suffer from significant losses due to bit errors and handoffs. TCP responds to all losses by invoking congestion control and avoidance algorithms, resulting in degraded end-to-end performance in wireless and lossy systems. In this paper, we compare several schemes designed to improve the performance of TCP in such networks. We classify these schemes into three broad categories: end-to-end protocols, where loss recovery is performed by the sender; link-layer protocols, that provide local reliability; and split-connection protocols, that break the end-to-end connection into two parts at the base station. We present the results of several experiments performed in both LAN and WAN environments, using throughput and goodput as the metrics for comparison. Our results show that a reliable link-layer protocol that is TCP-aware provides very good performance. Furthermore, it is possible to achieve good performance without splitting the end-to-end connection at the base station. We also demonstrate that selective acknowledgments and explicit loss notifications result in significant performance improvements.

TCP is a reliable transport protocol tuned to perform well in traditional networks made up of links with low bit-error rates. Networks with higher bit-error rates, such as those with wireless links and mobile hosts, violate many of the assumptions made by TCP, causing degraded end-to-end performance. In tbis paper, we describe the design and implementation of a simple protocol, called the snoop protocol, that improves TCP performance in wireless networks. The protocol modifies network-layer software mainly at a base station and preserves end-to-end TCP semantics. The main idea of the protocol is to cache packets at the base station and perform local retransmissions across the wireless link. We have implemented the snoop protocol on a wireless testbed consisting of IBM ThinkPad laptops and i486 base

TCP is a reliable transport protocol tuned to perform well in traditional networks where congestion is the primary cause of packet loss. However, networks with wireless links and mobile hosts incur significant losses due to biterrors and handoff. This environment violates many of the assumptions made by TCP, causing degraded end-toend performance. In this paper, we describe the additions and modifications to the standard Internet protocol stack (TCP/IP) to improve end-to-end reliable transport performance in mobile environments. The protocol changes are made to network-layer software at the base station and mobile host, and preserve the end-to-end semantics of TCP. One part of the modifications, called the snoop module, caches packets at the base station and performs local retransmissions across the wireless link to alleviate the problems caused by high bit-error rates. The second part is a routing protocol that enables low-latency handoff to occur with negligible data loss. We have im...

Transport connections set up over wireless links are frequently plagued by problems such as { high bit error rate (BER), frequent disconnections of the mobile user, and low wireless bandwidth that may change dynamically. In this paper, we study the e ects of frequent disconnections and low variable bandwidth on TCP throughput and propose a protocol that addresses this problem. We discuss the implementation (in NetBSD) of our protocol called M-TCP and compare its performance against other mobile TCP implementations. We show that M-TCP has two signi cant advantages over other solutions: (1) it maintains end-to-end TCP semantics and, (2) it delivers excellent performance for environments where the mobile encounters periods of disconnection. 1

Abstract. Wireless wide-area networks (WWANs) are characterized by very low and variable bandwidths, very high and variable delays, significant non-congestion related losses, asymmetric uplink and downlink channels, and occasional blackouts. Additionally, the majority of the latency in a WWAN connection is incurred over the wireless link. Under such operating conditions, most contemporary wireless TCP algorithms do not perform very well. In this paper, we present WTCP, a reliable transport protocol that addresses rate control and reliability over commercial WWAN networks such as CDPD. WTCP is rate-based, uses only end-to-end mechanisms, performs rate control at the receiver, and uses inter-packet delays as the primary metric for rate control. We have implemented and evaluated WTCP over the CDPD network, and also simulated it in the ns-2 simulator. Our results indicate that WTCP can improve on the performance of comparable algorithms such as TCP-NewReno, TCP-Vegas, and Snoop-TCP by between 20 % to 200 % for typical operating conditions.

There is general belief that networks based on wireless technologies have much higher error rates than those based on more traditional technologies such as optical fiber, coaxial cable, or twisted pair wiring. This difference has motivated research on new protocol suites specifically for wireless networks. While the error characteristics of wired networks have been well documented, less experimental data is available for wireless LANs. In this

Transmission Control Protocol (TCP) assumes a relatively reliable underlying network where most packet losses are due to congestion. In a wireless network, however, packet losses will occur more often due to unreliable wireless links than due to congestion. When using TCP over wireless links, each packet loss on the wireless link results in congestion control measures being invoked at the source. This causes severe performance degradation. In this paper, we study the effect of (a) burst errors on wireless links, (b) packet size variation on the wired network, (c) local error recovery by the base station, and (d) explicit feedback by the base station, on the performance of TCP over wireless networks. It is shown that the performance of TCP is sensitive to the packet size, and that significant performance improvements are obtained if a `good' packet size is used. While local recovery by the base station using link-level retransmissions is found to improve performance, timeouts can still ...

Unlike wired networks, packets transmitted on wireless channels are often subject to burst errors which cause back to back packet losses. Most wireless LAN link layer protocols recover from packet losses by retransmitting lost segments. When the wireless channel is in a burst error state, most retransmission attempts fail, thereby causing poor utilization of the wireless channel. Furthermore, in the event of multiple sessions sharing a wireless link, FIFO packet scheduling can cause the HOL blocking effect, resulting in unfair sharing of the bandwidth. This observation leads to a new class of packet dispatching methods which explicitly take wireless channel characteristics into consideration in making packet dispatching decisions. We compare a variety of channel state dependent packet (CSDP) scheduling methods with a view towards enhancing the performance of transport layer sessions. Our results indicate that by employing a CSDP scheduler at the wireless LAN device driver level, signif...

TCP has been designed and tuned to perform well under the assumption that all losses are an indication of congestion. When a TCP connection traverses a wireless link, packets may be lost due to wireless transmission errors, in addition to congestion losses. TCP implicitly assumes that all packet losses are due to congestion, and triggers congestion control mechanism when a packet loss is detected. It has been previously demonstrated that this feature of TCP affects performance adversely when packets are lost due to transmission errors. To avoid the performance degradation, techniques to distinguish between corruption and congestion losses without any explicit information from the network (routers or switches) are of interest.

Optimizing TCP (Transport Layer) for mobility has been researched extensively. We present a brief summary of existing results which indicates that most schemes require intermediaries (such as base stations) to monitor the TCP traffic and actively participate in flow control in order to enhance performance. Although these methods simulate end-to-end semantics, they do not comprise true end-to-end signaling. As a result, these techniques are not applicable when the IP payload is encrypted. For instance IPSEC, which is expected to be standard under IPv6, encrypts the entire IP payload making it impossible for intermediaries to monitor TCP traffic unless those entities are part of the security association. In addition, these schemes require changes (in the TCP/IP code) at intermediate nodes making it difficult for the mobile clients to inter-operate with the existing infrastructure. In this paper we explore the "Freeze-TCP" mechanism which is a true end-to-end scheme and does not require ...