Transmit beamforming and receive combining are simple methods for exploiting the significant diversity that is available in multiple-input and multiple-output (MIMO) wireless systems. Unfortunately, optimal performance requires either complete channel knowledge or knowledge of the optimal beamforming vector which are not always realizable in practice. In this correspondence, a quantized maximum signal-to-noise ratio (SNR) beamforming technique is proposed where the receiver only sends the label of the best beamforming vector in a predetermined codebook to the transmitter. By using the distribution of the optimal beamforming vector in independent identically distributed Rayleigh fading matrix channels, the codebook design problem is solved and related to the problem of Grassmannian line packing. The proposed design criterion is flexible enough to allow for side constraints on the codebook vectors. Bounds on the codebook size are derived to guarantee full diversity order. Results on the density of Grassmannian line packings are derived and used to develop bounds on the codebook size given a capacity or SNR loss. Monte Carlo simulations are presented that compare the probability of error for different quantization strategies.

Cooperative diversity is a transmission technique where multiple terminals pool their resources to form a virtual antenna array that realizes spatial diversity gain in a distributed fashion. In this paper, we examine the basic building block of cooperative diversity systems, a simple fading relay channel where the source, destination and relay terminals are each equipped with single antenna transceivers. We consider three different TDMA-based cooperative protocols that vary the degree of broadcasting and receive collision. The relay terminal operates in either the amplify-and-forward (AF) or decode-and-forward (DF) modes. For each protocol, we study the ergodic and outage capacity behavior (assuming Gaussian code books) under the AF and DF modes of relaying. We analyze the spatial diversity performance of the various protocols and find that full spatial diversity (second-order in this case) is achieved by certain protocols provided that appropriate power control is employed. Our analysis unifies previous results reported in the literature and establishes the superiority (both from a capacity as well as a diversity point-of-view) of a new protocol proposed in this paper. The second part of the paper is devoted to (distributed) space-time code design for fading relay channels operating in the AF mode. We show that the corresponding code design criteria consist of the traditional rank and determinant criteria for the case of co-located antennas as well as appropriate power control rules. Consequently space-time codes designed for the case of co-located multi-antenna channels can be used to realize cooperative diversity provided that appropriate power control is employed.

It has been shown that a complex orthogonal design that provides full diversity and full transmission rate for a space–time block code is not possible for more than two antennas. Previous attempts have been concentrated in generalizing orthogonal designs which provide space–time block codes with full diversity and a high transmission rate. In this work, we design rate one codes which are quasi-orthogonal and provide partial diversity. The decoder of the proposed codes works with pairs of transmitted symbols instead of single symbols.

We propose a systematic method for creating constellations of unitary space–time signals for multiple-antenna communication links. Unitary space–time signals, which are orthonormal in time across the antennas, have been shown to be well-tailored to a Rayleigh fading channel where neither the transmitter nor the receiver knows the fading coefficients. The signals can achieve low probability of error by exploiting multiple-antenna diversity. Because the fading coefficients are not known, the criterion for creating and evaluating the constellation is nonstandard and differs markedly from the familiar maximum-Euclidean-distance norm. Our construction begins with the first signal in the constellation—an oblong complex-valued matrix whose columns are orthonormal—and systematically produces the remaining signals by successively rotating this signal in a high-dimensional complex space. This construction easily produces large constellations of high-dimensional signals. We demonstrate its efficacy through examples involving one, two, and three transmitter antennas.

We explore in this letter the lattice sphere packing representation of a multi-antenna system and the algebraic space--time (ST) codes. We apply the sphere decoding (SD) algorithm to the resulted lattice code. For the uncoded system, SD yields, with small increase in complexity, a huge improvement over the well-known V-BLAST detection algorithm. SD of algebraic ST codes exploits the full diversity of the coded multi-antenna system, and makes the proposed scheme very appealing to take advantage of the richness of the multi-antenna environment. The fact that the SD does not depend on the constellation size, gives rise to systems with very high spectral efficiency, maximum-likelihood performance, and low decoding complexity.

This paper presents an overview of recent progress in the area of multiple-input–multiple-output (MIMO) space–time coded wireless systems. After some background on the research leading to the discovery of the enormous potential of MIMO wireless links, we highlight the different classes of techniques and algorithms proposed which attempt to realize the various benefits of MIMO including spatial multiplexing and space–time coding schemes. These algorithms are often derived and analyzed under ideal independent fading conditions. We present the state of the art in channel modeling and measurements, leading to a better understanding of actual MIMO gains. Finally, the paper addresses current questions regarding the integration of MIMO links in practical wireless systems and standards.

We derive performance limits for two closely related communication scenarios involving a wireless system with multiple-element transmitter antenna arrays: a point-to-point system with partial side information at the transmitter, and a broadcast system with multiple receivers. In both cases, ideal beamforming is impossible, leading to an inherently lower achievable performance as the quality of the side information degrades or as the number of receivers increases. Expected signal-tonoise ratio (SNR) and mutual information are both considered as performance measures. In the point-to-point case, we determine when the transmission strategy should use some form of beamforming and when it should not. We also show that, when properly chosen, even a small amount of side information can be quite valuable. For the broadcast scenario with an SNR criterion, we find the efficient frontier of operating points and show that even when the number of receivers is larger than the number of antenna array ...

This is the second in a two-part series of papers on a new form of spatial diver- sity, where diversity gains are achieved through the cooperation of mobile users. Part I described the user cooperation concept and proposed a cooperation strategy for a conventional CDMA system. Part II investigates the cooperation concept further and considers practical issues related to its implementation. In particular, we investigate the optimal and suboptimal receiver design, and present performance analysis for the conventional CDMA implementation proposed in Part I. We also consider a high rate CDMA implementation and a cooperation strategy when assumptions about the chan- nel state information at the transmitters are relaxed. We illustrate that, under all scenarios studied, cooperation is beneficial in terms of increasing system throughput and cell coverage, as well as decreasing sensitivity to channel variations.

The vision is tantalizing: a high-performance, scalable, and widely deployed wireless Internet that facilitates services ranging from radically new and unforeseen applications to true wireless "broadband" to residences and public spaces at rates of 10s of Mb/sec. However, while high-speed wireless access is easy to achieve in an enterprise network via low-cost IEEE 802.11 (WiFi) access points, wireless technology in public spaces is in its infancy. "Hot spots" provide high-speed wireless access, but do so in very few isolated "islands" at immense costs. Likewise, while fixed wireless (e.g. LMDS) and 3G can provide ubiquitous coverage and 3G can support mobility, throughputs can often be two orders of magnitude slower than WiFi.

this paper, we show how to design signal matrices satisfying these requirements. As shown in [1], the design problem for unitary space time constellations is the following: let